Ok,Got the trans against the block,have to admit , went right into place,has enough torq convertor space,only thing I have noticed,around the rear support is tight and I extended the pressure switch for clearance,gonna have to make alittle room around the support,about a 1/2 inch of so for the correct angle,this is a quick pic and is not finished,gonna raise the trans about another 1/2 inch,so far the only fabrication is gonna be for the shifter linkage,gonna install a Lokar kit for throttle pressure,gonna finish up some small crap tomorrow,hopefully this weekend ,if the driveshaft is done a trail test on the lift...

nother...

Sorry Bear is bored and waiting....

Your getting closer and closer to having her done

looks great Ricster

here i lowered your truck to save you the work man photo shop is fun

it really dosnt but this does even though it isnt a mopar at all its stilll bad ars

i feel stupid whos ric the truck i just did mmm ok give me sometime

the one above that you did the photo shop work to, you know, to make it a low rider....
Ric own's it....

Don't feel like pics tonight,(tired) the trans is all the way in ,cept for the shifter bracket,driveshaft fits great, hope to move it tomorrow,gotta wire the hot wire yet,made the new cooler lines tonight,getting there..Carlisle is starting to look better...

schweet

It moves !!!In the morning I will run the wire for the overdrive....

As I said before ,,,Looking GoooooD

still have aot of work ahead of me,way too dirty...

Webster you better be at Carlisle.......last buffed and not!