A and a valve body - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech A and a valve body

Print Thread

A and a valve body #2141918 08/27/16 03:13 PM 08/27/16 03:13 PM
Joined: Nov 2010 Posts: 61 ohio S slomoshun OP member
slomoshun OP member S Joined: Nov 2010 Posts: 61 ohio	What is band adjustment when using a and a valve body it is reverse manual with no transbrake part number22770-2wb.

Re: A and a valve body [Re: slomoshun] #2142001 08/27/16 04:54 PM 08/27/16 04:54 PM
Joined: Jan 2003 Posts: 26,002 Rio Linda, CA John_Kunkel Too Many Posts
John_Kunkel Too Many Posts Joined: Jan 2003 Posts: 26,002 Rio Linda, CA	What ratio is the kickdown band lever? The INTERNET, the MISinformation superhighway

Re: A and a valve body [Re: slomoshun] #2142535 08/28/16 04:17 PM 08/28/16 04:17 PM
Joined: May 2004 Posts: 1,522 Ste-Sophie, Quebec, Canada W Wedgeman pro stock
Wedgeman pro stock W Joined: May 2004 Posts: 1,522 Ste-Sophie, Quebec, Canada	let's say 4.2.........

Re: A and a valve body [Re: Wedgeman] #2142616 08/28/16 06:25 PM 08/28/16 06:25 PM
Joined: Jan 2003 Posts: 26,002 Rio Linda, CA John_Kunkel Too Many Posts
John_Kunkel Too Many Posts Joined: Jan 2003 Posts: 26,002 Rio Linda, CA	Two turns out should work OK. The INTERNET, the MISinformation superhighway

Re: A and a valve body [Re: slomoshun] #2142766 08/28/16 10:29 PM 08/28/16 10:29 PM
Joined: Feb 2005 Posts: 5,207 Menomonee Falls DemonDust master
DemonDust master Joined: Feb 2005 Posts: 5,207 Menomonee Falls	Both bands go to 72 in/lbs. Then back off Front band 2 turns rear band 4 turns for 904. SDG Motorsports Hellcat Demon and Redeye Supercharger CNC Porting https://www.sdgmotorsports.com/

Re: A and a valve body [Re: slomoshun] #2142768 08/28/16 10:30 PM 08/28/16 10:30 PM
Joined: Feb 2005 Posts: 5,207 Menomonee Falls DemonDust master
DemonDust master Joined: Feb 2005 Posts: 5,207 Menomonee Falls	I believe the rear band (low gear) is 2 on 727. Last edited by R5P7Duster; 08/29/16 12:52 PM. SDG Motorsports Hellcat Demon and Redeye Supercharger CNC Porting https://www.sdgmotorsports.com/

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1