70 Cuda Rocker Molding Question - Moparts Forums

Register Log In Moparts Forums Moparts Restoration & A12 Forum 70 Cuda Rocker Molding Question

Print Thread

70 Cuda Rocker Molding Question #1970643 12/16/15 02:14 AM 12/16/15 02:14 AM
Joined: Mar 2011 Posts: 136 Oceanside CA R relax383 OP member
relax383 OP member R Joined: Mar 2011 Posts: 136 Oceanside CA	Quick question about 70 Cuda Gill Rocker Moldings. I have heard they are standard on all Cuda models? Is this true?

Re: 70 Cuda Rocker Molding Question [Re: relax383] #1970646 12/16/15 02:17 AM 12/16/15 02:17 AM
Joined: Jan 2003 Posts: 29,650 Hamtramck, PA A Alaskan_TA Fluffy Balladeer
Alaskan_TA Fluffy Balladeer A Joined: Jan 2003 Posts: 29,650 Hamtramck, PA	Except for the AARs. Rumors exist that a few AARs left the factory with them, but so far I have not seen any proof of that.

Re: 70 Cuda Rocker Molding Question [Re: relax383] #1970895 12/16/15 04:33 PM 12/16/15 04:33 PM
Joined: Mar 2011 Posts: 136 Oceanside CA R relax383 OP member
relax383 OP member R Joined: Mar 2011 Posts: 136 Oceanside CA	Thank you sir. I have a U code 440 cuda just wanted to make sure I was putting all the right stuff back on it. Brad

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1