I am just buried and took on a little too much....

Still finishing the suspension install

Still finishing the brakes

Still finishing the radiator mod to move it forward

Still finishing the lettering.

Still installing the seat

Didn't even get to installing the volt meter and ditching the amp meter

Didn't even get to wiring in the new line lock button on the shifter

Haven't started the annual trailer maintenance

And still haven't fixed the brake controller

Season opened last week..........


HOLY COW MAN!

I'm doing about the same! Finishing my brothers New engine now, my wife's car needs header teathers and a few small things to get it out. My engine is disassembled. Tow vehicle has been parked since November and needs gone over. Trailer needs gone over. And customer projects are in the way first.

I'm hoping to get my brothers to him in time to have his ready for the 18th. And I want my wifes car there too. Maybe Ill get mine together for fall.
Keith

If I race anything this year its gonna be the Rampage..
but I'm moving some front end parts around to lift
it 1" and I'm moving the rack back 1 1/4"... I need
to fix the brake lights on my hauler... without the
brake lights the trailer brakes dont get activated

NOT READY

Trailers done new roof bows and ceiling panels installed, roof resealed(crushed from snow). I'll be starting this week. Pull the pan to check the bearings. Pull the trans to install aluminum drum and freshen.
I'll be testing on the 10th.
Doug

I was out for my 2nd time this year last night. Went out in the third round with a red light. Did run it out to a 5.99 after I went red. So it's running pretty good. I added 25# to the nose to help keep the front end down and that seems to help. So ill be back out Friday running bracket two again.

I'm not even close . Still porting my heads need to rebuild the carb , get a fiberglass hood and mount the scoop and on and on....
I need to buy a trailer also.

Same here... Still have to get both car and engine back then put it all together hoping to at least make a few passes by mid season.

So I am not the only one....

Forgot, the trans on the truck needs its annual maintenance...Days are too short.

Need one more good weather weekend, as I'm working outside.

As you can see by my brothers post I don't have the motor in mine.... When it's back I need to finish the motor plate, figure out how I'm mounting the alternator, install the tach and do an alignment on it. I have the truck and trailer ready to go. I told my wifey if my car isn't ready for May 18th race at Martin I'd have to race her 2010 Challenger!! She didn't seem to like that idea....

Short block is on the engine stand .

We proved yesterday @ Grudge-Fest we are ready!

For the first time in my life........I am ready.

I have gotten quite a bit done, but still a lot to go...

not to mention this is a new car that I have never made a pass in

- alignment
- wideband install
- fuel pressure gauge wiring (with datalog)
- shift light wiring
- nitrous solenoid wiring
- progressive controller/MSD retard/nitrous control switches/relays, plus finding a place to mount everything


Then once I am ready, I need to shake it down in street trim and figure out what the new tires/shocks like...then I'll try to go fast

Fresh port job on the heads New custom grind cam New replacement piston from Wiseco.... 4 months and counting.....

Not me, still gathering parts. Hopefully for 2015 though.

Need to build new motor, get new shocks, ignition and timing controller, alternator, and most important the funds to make it all fall in place

The car is ready to go. The drivers head (mine) has been repaired,contrasted,radiated and must go thru a 1-3 year healing process!