I've been trying to use Eastwood's Rust Dissolver. believe this is very similar to evaporust. I literally cannot use this without flash rust appearing. have tried many things....rinsing with water and drying immediately, not rinsing only wiping, wiping and straight in warm oven (200 degrees), etc.... always flashes in literally seconds though......air is very dry now as well

product does remove the rust well after tanking. however, in the end i have a larger percentage of the surface of the part covered with flash than was there originally.....

same issue with evaporust?

Last edited by BTTG; 04/20/11 08:41 AM.