Quote:

For every .010 off of the deck surface you need to remove .0123 off of the intake surface, but before you go crazy on the head I would probably look at the intake, because if you start milling the intake surface of the head, you going to end up with a head with very little valve cover rail. click on the link for milling info http://www.mopar1.us/mill.html




Yeah, I remember the .123?/.0123 number from memory. I was too lazy to look it up. Thanks for the clarification. The result is the same dimension.

I remember Jeff cutting my Eddys .030". I ended up cutting the intake manifold .040" but I also used .060" Ultra Seal gaskets without the pan.

Last edited by 64Post; 04/17/11 12:11 PM.