Quote:

---

Quote:

---

i ran the isky 8005A with the same set up that you have but with 1.6 indy roller rockers. mopar65

---

did u have to cut the seat pockets for the smaller id of the inner spring? or did u just shim for the difference in installed height between the edelbrock and isky recomend, i think the difference is only .010" is that enough to worry about? [/quot

Hi no there is enough room that the springs fit fine and i did not reshim them. i checked a few to compare and thye were so close on mine i did not think it was the worth the trouble to shim the new springs. i used the stock valves but went to a 10 degree reatainer/keeper that set up worked fine for the 3 years i had the car untill i sold it.thanks mopar 65