I think that I have excessive oiling to the rockers....

World product alum block, B1MC heads (front and back oil rtns) with jesel rockers. Tall isky ez roll lifters for pushrod oiling .090 orfice. Manton hollow pushrods with a .075 orfice in them. Priming the engine I have about 75-80 pounds. I roll the motor over with a breaker bar to see if the oil is reaching the rocker. All are getting oil but the outer lifters ie 1 exhaust and 7 exhaust are getting less oil. I am using Brad Penn break in getting ready for the dyno. I spun the drill rotating the motor for about three minutes then let it sit. I removed the valve cover and seen where the oil was sitting in the valve cover about and inch up from the mounting surface of the valve cover. I know that B1 have terrible drain back. So what do you guys think too much oil to the top?

Mike