Got a new set of K1 Technologies I-Beam rods with ARP 2000 rod bolts for a 340 small block. K1 does not list a torque specification for these bolts. They require either a stretch guage or a torque angle guage. The specs say 35 ft pound plus 50 degree angle on the torque angle guage. No one in this area has one of the angle guages. They advertise that Sears and Snap on have not but not in my area have to order and wait. Does anyone know what the torgue reading with a normal 1/2" drive torque wrench would be for this 35 ft pounds plus 50 degrees.