Thanks for the replies - I'll check the measurements as soon as I get home.

Quote:

---

What bellhousing are you using and did you buy a new adjuster rod?

---

1. Bellhousing - on the car when I bought it 6 years ago. To answer your question, would I look for a casting number on it? Or take some measurements??

2. Adjuster rod - I did buy a new clutch linkage rod, but I still have the previous one, and they are the exact same. I had a post last week with a picture of the new one, along with the Z-bar bushings and ball studs.
I used all of the new parts, just kept the old Z-bar.


Other Z-Bar Post

Also, I explained in the other post that the old Z-bar never did sit right, due to the bent frame (where the U-slot is) that the left ball stud fits into.

I thought that after I straightened that out, it would sit right but I still have a bit of an angle between the Z-bar and the throwout bearing fork.