Offset motor.....centered rear end pinion

Print Thread

Offset motor.....centered rear end pinion #680912 04/26/10 06:18 PM 04/26/10 06:18 PM
Joined: Sep 2005 Posts: 115 Manteca, CA DRJDVM OP member
DRJDVM OP member Joined: Sep 2005 Posts: 115 Manteca, CA	How many of you guys are running the stock offset motor position, but have the rearend pinion dead center (the actual yoke is dead center...same measurement from yoke to flange on each side)??...i.e the yoke not offset to the pass side like the motor...... Other than tunnel clearence, is there any problems in doing that?

Entire Thread
Subject	Posted By	Posted
Offset motor.....centered rear end pinion	DRJDVM	04/26/10 10:18 PM
Re: Offset motor.....centered rear end pinion	Bill MeLater	04/27/10 03:32 AM
Re: Offset motor.....centered rear end pinion	Scott Carl	04/27/10 04:28 AM
Re: Offset motor.....centered rear end pinion	Kern Dog	04/27/10 04:32 AM
Re: Offset motor.....centered rear end pinion	DRJDVM	04/30/10 03:19 PM

Hop To