I like it too, but really want to add the crash bar. I'll have to check how it all fits later.

A couple other points; the dash shifter area is a regular hole in the dash, no flange or lip. It also has an additional bracker spotwelded behind. I will not have to change dashes or section in part of it. I'll cut the opening and then weld in the backing part.

I got the filler neck out. As was mentioned on another site, the bottom of the box that it fits in is simply press fit. I used a hammer and a long rod to pop it out from the tail light opening.
The van is all cleared out now, and the rotisserie has been dropped off. I still need to do some more on it while on solid ground, and the brackets needed a bit more finessing, so it's still not hung yet.