Quote:

Quote:

I think I greased up the input shaft but cant remember for sure..... Dang it!!!



You are not supposed to grease the input shaft pilot or splines. The factory service manual says to put grease in the bearing instead. If you grease the input shaft it is almost impossible to get the shaft through the disc hub without getting any on the hub. if you get any on the hub or splines it will sling out on the disc and cause chatter.



Good point. I pretty sure I didn't grease it up but after I had heard about it I started to wonder if I did or not. I know I greased up the bearing though.


Solid Tranny mount with poly motor mounts. It is definately from the rear.


I'm pulling the tranny out as soon as the weather cools down.

A~