A couple guys showed interest in this so here is a pic.

Dimensions of the shroud are 18"tall, 24"Wide, and it's 3.5" at it's thickest point (where the motors stick out).

Right in the middle, though, where most pullies or water pumps might interfere, it is only 3" thick, and that + the capacity of it might make it a winner for certain apps....

.....as long as there's enough alternator to power it up.

Haven't measured current draw but I suspect it is an amperage hog. I've been looking at it for a swap using a 136A Denso (stock 5.7 truck alternator) for a street car I'm fooling around with....and wouldn't recommend too much less alternator than that.

The mounting points are roughly 26" wide, and as said in the other post...it actually appears the whole radiator with the shroud could probably be fit into an old Mopar without too much trouble. Either that or the fan could be used on a universal style radiator if the stock mounting is cut off, and a few little brackets made up.