Originally Posted by moparx
you don't have to jump those terminals.
all that is needed is to wire the G terminal to the mounting bolt, completing the ground circuit. [a spade connector, short piece of wire, and a ring connector terminal]
however, doing that allows the car to start in any gear, so BE VERY CAREFUL if you do this !
beer

edit : the above i posted is used to bypass the NSS using the key to start the car. using a bump switch to run the valves requires hooking up the switch as the picture indicates.
sorry if i caused any confusion !

URR Butt crack was showing on that one 🤣🤣🤣🍻

BTW jumping the terminals will make the car move if in gear with a Standard trans. But it usually doesn't take long for one to figure that out. Especially if the front of the car is on jacks stand's or such wink

beer

Last edited by TJP; 11/10/23 11:35 PM.
www.tandmautomotive-omaha.com