If no one provides an answer in next couple of days, I can take some measurements.
Just need to do some musical cars.
Poster has been in a struggle and I doubt any one will help him. Simple center to floor measurement is all he needs.
Thank you, I appreciate it
Ok I have a 70 Cuda with a 426 hemi 4-speed. The block is one of the hemi's that has the factory big block ears and uses wedge motor mounts instead of hemi motor mounts so they bolt up to the factory k frame the same as a wedge. So the engine and transmission are both installed in the factory location with factory mounts.
I went out and crawled under it and the best I can measure is it's between 2 1/4" to 2 3/8" from the top of tail shaft to floor pan. Floor to center of tail shaft (center of yoke) between 3 1/2" to 3 5/8".
Hope this helps
Mike