Converting from Lean Burn to standard ignition

Print Thread

Re: Converting from Lean Burn to standard ignition [Re: elmor353] #3069241 08/18/22 02:41 PM 08/18/22 02:41 PM
Joined: Jan 2003 Posts: 4,163 Canada -- Posts: 4034 -Registe... 5 5thAve Doesn't care what this says anyway
5thAve Doesn't care what this says anyway 5 Joined: Jan 2003 Posts: 4,163 Canada -- Posts: 4034 -Registe...	There's no real doing it from scratch, go back to the starter relay and leave the rest alone. 1979 had a ballast resistor in the setup. If 1980 still had the ballast resistor too half the work is already done for you.

Entire Thread
Subject	Posted By	Posted
Converting from Lean Burn to standard ignition	TX9H6E4CUDA	08/17/22 10:05 PM
Re: Converting from Lean Burn to standard ignition	elmor353	08/17/22 11:56 PM
Re: Converting from Lean Burn to standard ignition	5thAve	08/18/22 06:41 PM
Re: Converting from Lean Burn to standard ignition	ThermoQuad	08/18/22 06:51 PM
Re: Converting from Lean Burn to standard ignition	njmopar	08/19/22 01:34 PM
Re: Converting from Lean Burn to standard ignition	Magnumguy	08/19/22 01:43 PM
Re: Converting from Lean Burn to standard ignition	a12rag	08/19/22 02:55 PM
Re: Converting from Lean Burn to standard ignition	larrymopar360	08/19/22 10:05 PM
Re: Converting from Lean Burn to standard ignition	DAYCLONA	08/20/22 02:45 AM
Re: Converting from Lean Burn to standard ignition	Moparite	08/20/22 03:03 PM
Re: Converting from Lean Burn to standard ignition	Wheeler	08/20/22 06:04 PM
Re: Converting from Lean Burn to standard ignition	elmor353	08/20/22 07:48 PM
Re: Converting from Lean Burn to standard ignition	Moparite	08/21/22 03:07 PM
Re: Converting from Lean Burn to standard ignition	Sniper	08/21/22 03:35 PM

Hop To