Bought a Dana while on the Carlisle trip.
I want to install longer wheel studs and I doubt they can be installed without pulling the axles so ... are the axles only held in by the bearing retainers or does the rear cover have to come off for some reason?
Springs have been moved inboard so I also need to remove the spring perches and install new ones. Do I have to pretty much gut the rear end or can I just weld them on as is? The rear has no fluid in it but there is probably residue on the insides of the tubes.
Dana 23,44, 52 or 60 series?
If a 60 the axles should slide out, you may need to pry on them at first to make them move depending on where it was from and what condition the outer bearings are in
