After supplying a BB Mopar bellhousing, 8-bolt manual transmission flywheel, starter, etc. the dyno shop that said they will test my engine called and said they can't do it.
Their dyno mounting has several hole patterns (trans patterns) to bolt the dyno to the engine bellhousing; but none fit the Chrysler A833 manual transmission.
A833
5.28" wide top holes
7.125" wide bottom holes
7.875" height from top to bottom holes
Jim if we lived closer I could lend you the Lakewood blowshield we used for the Enginemasters , I drilled the needed hole pattern in it so that wouldn't have been an issue.
On that note if it would work I can ship it to you and pick it up on my way back from FL. late May , early June ?
