All good TJP, I am learning as I go. I found some resistors that are close. 330 ohm and 360 ohm. These are 1/8w with 1%. They are also the metal film type vs. the carbon film of the originals, which is why the tolerance is better I take it. I asked an electrical engineer if it was OK to use the metal film vs. the carbon and he is it is OK to do so. Now, my question is which ohm rating should I use? 360 is closer to the original 350, so I am leaning that direction. There still may be 1 350 ohm in the decoration that is working properly (I didn't need to change out those leds as all were working) so I am thinking that that the 360 will keep the replaced leds to an equal brightness. What do you think?