hi
i need a part no /brand a doul master cylinder with a 15/16" bore .

would like allum

2 or 4 bolt mount ok .

front disc / rear drum

thank you !



called doctor diff no answer left message no cal back after 3 days ?

soooo what to doo now ?

got a new m c i had lay in around from a swap meet buy cost $5 .

re moved the piston stuck it in the lathe , bored the hole to 7/16" dia

went in app 3/8 from bore opening and inlarged hole some app 3/8 in length .

this is a step for the rubber rod holder

put some silicone grease on and rod snapped right in .

had one of the 4 hole to two hole adapters layin around dont know where i got it ?

put m c on and drilled holes in two old caps and had the plastic bleeders you get with new master cylinders .

stuck them on there , to do it correctly the hose must be in the fluid in resivour to get all air out

pump slow app 20 times till no air.

hook up lines , bleed brakes .

pedal feels good , test drive tomrow if no rain !

old mc was 1-1/8 heavy c i , new light alu mopar mc part no 520066828

hope this helps someone.










'

Last edited by calrobb2000; 08/21/21 11:37 PM. Reason: update