Originally Posted by qwkmopardan
This was a build for a buddys 1968 Satelite

.055 over 1966 440 block
NOS cast crank--3.75 stroke--internal balance--no Mallory metal
Eagle 6.76 rods for .990 pins
JE Flat top piston--.025 in the hole--CR 10.5 to 1--Runs on 93 oct pump gas
Racer Brown Solid lifter flat tappet cam--STX-21--272*/272*-.560"/.560"
Edelbrock Performer RPM heads with a decent port job and a Red CC inner spring added--shaved .040
Victor Intake w 1000CFM Carb Shop Carb-4150
Hooker competition headers--1 7/8" primary tubes
Dynamic 9 1/2" TQ Converter
Dana 60 W/Spool and 4.10 Gear set
3600# SS Springs w/ no snubber or anything else
29x 10.5" MT stiff side wall slicks
drivers seat--heater delete full C/M cage-- aprox 3500# w driver

10.29 at 129.xx MPH--1.39 60ft

[Linked Image]



https://board.moparts.org/ubbthread...e-440-stock-stroke-10-second-combos.html

One day id like to try the trick flow heads with the STX-21 and see if it runs anything like the combo above. I don’t know the car or poster but it is a stock stroke pump gas low 10 second combo in your weight range.


Now I need to pin those needles, got to feel that heat
Hear my motor screamin while I'm tearin up the street