The method I was taught many years ago to has never failed me.

EO/IC rule (Exhaust Opening and Intake Closing). using a remote starter button/ switch to bump the motor around

Set the intake valve when the exhaust valve is beginning to open. This will put the intake lifter at the base circle which is where you want it to be.

Then set the exhaust valve when the intake valve is almost closed.

I have trouble remembering the above, so I wrote it on a piece of cardboard and prop it up for referencing as I adjust each valve

If adjusting hydraulics, loosen the adjuster until there is noticeable play between the rocker and pushrod / valve

While rolling the pushrod between two finger tips, begin slowly tightening the adjuster.

Just as you hit Zero lash you will feel a slight but distinct resistance. You can loosen a 1/4 turn or so and retighten to confirm several times until you get the "hang" of it.

The above resistance will be felt even with empty lifters. You will also note the " free play" is gone.

From that point, depending on adjusters threads per inch determines how far to tighten. Most are 3/8 x 24. So if one divides 1inch by 24 =.0416" per turn. All camshaft Manufacturers' I am aware of recommend. 0.020" to .040" preload.

With the above, I have always used 1/2 turn beyond zero lash.

I also agree with starting at the front of the motor, and do each valve working towards the back. Then repeat the process on the other side