Originally Posted by KOS
Originally Posted by carnut68
Originally Posted by KOS
thx guys I believe the specs should be online but I appreciate the offer.....I think an M1 may work also and I found one gonna have to do some comparison.
The M/1 is a good bit taller than a Torker II. I can measure I have both. So far I have run 10.82 @ 125 with the Torker II. Gasket matched no spacer.


that would be great ! thx a lot ....to you also B1 duster for the offer and Tex I believe your correct the SD is the lowest.i have a raised area in the hood(cowl) .....its a factory 70 roadrunner hood so slightly taller in the centre.
the M/1 measured 5 1/2 on the front of the pad and 5 3/4 on the rear. The Torker II was 4 1/4. A TM7 I have was 4 3/8 on the front and 4 5/8 on the rear.

America First!