I don't have any flow sheets or claimed or actual flow numbers on them
The pushrod holes need work, enlarging, to make them clear the 3/8 diameter pushrods I'm using to check P to V clearances.
I put a set of mismatched rocker arms together using a set of Hughes 1.6 ratio offset extruded aluminum intake rocker arms for the Eddy Victor heads that i have and another set of CAT brand 1.7 ratio exhaust roller rocker arms.
I need to grind the pushrod holes to clear the push rods and recheck the P to V clearances as well as ratio at the valve retainers
I ordered a Speed Master brand 1.5 ratio roller rocker kit with shafts and hold downs, I'll see how they fit and what ratio they check out to be
I'm planning on dyno testing this 505 C.I. pump gas motor with these heads with a Team G intake with several different DP carbs. I have and jet the carbs for best HP