Originally Posted by JERICOGTX
Did you buy your block finished machined? 4.625 stroke? Was it ever on a dyno?



Get the block from Best , they know how to hone them, Or BES or other reputable shop. It is not like honing an iron block. They move around a lot when warm.
Then, if bracket racing, you going to need to figure out how to run it cool, 100* if possible so....I dont want to start that temperature debate , but i was told "run it as close to 100 as possible"

Last edited by n20mstr; 08/13/20 09:25 PM.
....BAD A$$ STREET CAR.....