Originally Posted by mopar65
Originally Posted by pittsburghracer
Originally Posted by fourgearsavoy
I've been building a Magnum based stroker for a friend and he's been getting run around from Mancini about the availability of Eddy Magnum cylinder heads. Any body else having trouble getting Magnum heads?

Gus beer





Just throwing this out there but did he ever consider running a much better Trickflow head. Made in the good old USA and better flowing.

Notes:Magnum engines must use Harland Sharp S72025K (1.5 ratio) or S72026K (1.6 ratio) shaft mount roller rocker arms for proper oiling.


https://www.trickflow.com/search/department/cylinder-heads
John Mike at B3 Racing is setting me up with some PRW Roller rocker arms that will do push rod oiling for the trick flow heads, that I put on my 2000 magnum 360 engine.




Nice. TrickFlow delayed their release of these heads many months and redesigned it to meet a larger need. Intakes were delayed for casting issues and I’m not sure if they are available yet or not. I look forward to more Mopar products from them in the future.

1970 Duster
Edelbrock headed 408
5.984@112.52
422 Indy headed small block
5.982@112.56 mph
9.42@138.27

Livin and lovin life one day at a time