AR valley pan review?

Print Thread

Re: AR valley pan review? [Re: PossessedDuster] #2766627 04/21/20 09:42 AM 04/21/20 09:42 AM
Joined: May 2011 Posts: 4,489 northern,Ohio,USA C Clanton master
Clanton master C Joined: May 2011 Posts: 4,489 northern,Ohio,USA	I was think of having a bar support like a factory setup but all 4 sides.I was also designing a lifter valley windage tray to prevent oil splash.I guess this gould go in up or down with a finger slot to grab it. Originally Posted by PossessedDuster Not sure what valley pan is currently on my 440 but I keep seeing oil at the front corners. I have edelbrock performer RPM heads and intake manifold. Is the AR engineering 1 piece aluminum plate a good fit for my set-up? Last edited by Clanton; 04/21/20 10:06 AM. GOTBOOST!New improved with Victor heads. http://www.enginelabs.com/mopar-big-bloc...t-of-necessity/

Hop To