has any one had a issue where electronic ignition had no fire but wiggle ignition module connector and then fires up, several modules and even new harness, could it be possible dist issue.
If you wiggle the rubber connector boot and the issue goes away it is not likely the distributor or ballast resistor. It is the connector.
I would use a small set of visegrip needle nose pliers and slightly,
just slightly crush the female bullet connectors inside the rubber boot.
Then using a long brass bristle brush clean the female bullet connector contacts inside the plug and the pins on the ECM box.
Smeer a small dollop of dielectric grease in the contacts and push it in place. You may need to use some force to get the female connector to push over the male ECM pins.