I am headed out to the shop to disassemble the engine some more. Pull the pump, and the crank.

I looked for Emery cloth and found 1" wide on a roll with 320 grit. I was really wanting a sheet. I can't find cotton sash cord to turn the cloth.

Can I accurately mic the journal with a vernier caliper with a gauge? I don't want to go too small.

BTW new standard Federal Mogul rod bearings are $3.99 each!!

If you buy a set it is $49.98!!

Fuzzy math!



Should I plastigauge the mains to decide on changing them?