Originally Posted by Den300
Originally Posted by Jeremiah
Run down this list:

https://www.ferrea.com/Chrysler-Engine-Valves/p34267

IIRC there is something that should work.


Been there before but they are all a bit too long. Will talk to my engine builder if that still fits with the springs and retainers. But thanks for suggestion up


So what if they are a bit too long? By how much? .060? .100? If so, you can use a different spring for the longer installed height and get the spring load back where it should be (if it's .060 or so I'd shim the spring you have).

Then, you go to b3racingengines.com and read ALL his tech pages. Then order a geometry correction kit and you are DONE.

If you do that, and you can use a bit longer valve out of a catalog, you'll most likely never get screwed again by not being able to by a valve off the shelf.

Just because you think it won't make it true. Horsepower is KING. To dispute this is stupid. C. Alston