Hi all,
I recently posted re inspecting solid roller lifters. Following the advice offered I am leaning towards replacing my lifters as I am uncertain of their age or history , and of my ability to assess them properly.
So after searching and reading here as much as I could I have narrowed down my choice to comp cams 96829-16 . Some of my engine info.
Bracket motor turns 6800
Springs are 250 on the seat . Spring rate listed as 545. ( I hear the term over the nose often, is the spec spring rate the same or is it something measure after install ?)
Lifter bores are unbushed
Do not need pr oiling (lifter spec says they are , but read a post by Andy F , said he bought a set and they were not)
Anybody using these for awhile ? They are in my budget and says they are rebuildable. Seem like a decent deal.
Thanks in advance, G