Originally Posted by Clanton
This is the best I could do to check it.
Originally Posted by Wirenut
Thanks Doug
Would clean and dry mean soaked in solvent or lacquer thinner to get the oil out and blow dry?
Not sure I’m following re the measurements. Do you mean measure the width of the wheels to see if something is mushrooming ?
Or just check the clearance between the roller and lifter body?
G

I'd move the indicator 90 degrees to check the axle. But you need an indicator that measures in ,000x". Still tough to get an accurate reading without a fixture. The width measurement is the body itself. Measure the body parallel to the axle with a mic.
Doug

Last edited by dvw; 01/02/20 06:16 AM.