I think the length of the input was different too. I haven't ordered the Dodge input yet. My bellhousing showed up a few minutes ago. I was going to try and find an old Lakewood smallblock bell and machine it to fit the NV4500 bearing retainer to keep my newly gone thru mechanical linkage which works great. The problem is that the length of the NP435 and NV4500 inputs are different by about .75 inches. I pulled the entire hydraulic slave cylinder assembly with all of the lines from the 95 1500 I removed the wiring harness from. It had an NV3500 in it. I will use it to mock up with. Should work.