Originally Posted By BcudaChris
Originally Posted By goldduster318

If you had a 26", the V6 Contour fan is basically the greatest thing since sliced bread. I don't even need the high speed the fans have.


How did you wire it? RockAuto pic looks like it has two connections (I assume 1 for each fan) and I didn't see a ground connection. It looks like there might be some logic, given the size of the cooling provisions in and the size of the box.

Did you just use a single relay with a temp sensor and run both fans together?

My application is an E body with 26" radiator.

Chris


I used a Dakota Digital controller. The speeds are controlled by the resistor/diode pack in the lower driver's corner. The two connections on the motor are power and ground. If you don't use the resistor, you get the high speed. Wiring diagram (maybe not real pretty but accurate). My car has an autometer electric gauge so it uses that as a temp sender.

Both fans will start and run at the same time. But the low speed on its own works well.

fanwiring.JPG
'70 Duster 470hp 340/T56 Magnum/8 3/4 3.23 Sure-Grip