Milling pockets in pistons

Print Thread

Re: Milling pockets in pistons [Re: mopfried] #2458569 02/27/18 09:02 PM 02/27/18 09:02 PM
Joined: Jan 2003 Posts: 738 Columbus Ohio M mopfried OP super stock
mopfried OP super stock M Joined: Jan 2003 Posts: 738 Columbus Ohio	The quench side of the wedge shape is right around .050" deep. The deck has been cut to put the pistons .005" in the hole.

Entire Thread
Subject	Posted By	Posted
Milling pockets in pistons	mopfried	02/26/18 03:43 AM
Re: Milling pockets in pistons	steve660	02/26/18 03:50 AM
Re: Milling pockets in pistons	polyspheric	02/26/18 04:13 AM
Re: Milling pockets in pistons	mopfried	02/26/18 04:25 AM
Re: Milling pockets in pistons	440_Offroader	02/26/18 04:49 AM
Re: Milling pockets in pistons	Sport440	02/26/18 05:13 AM
Re: Milling pockets in pistons	Blucuda413	02/26/18 05:02 AM
Re: Milling pockets in pistons	madscientist	02/26/18 05:25 AM
Re: Milling pockets in pistons	Pacnorthcuda	02/26/18 05:36 AM
Re: Milling pockets in pistons	mopfried	02/26/18 06:01 AM
Re: Milling pockets in pistons	polyspheric	02/26/18 07:10 AM
Re: Milling pockets in pistons	mopfried	02/26/18 04:18 PM
Re: Milling pockets in pistons	Sport440	02/27/18 03:53 AM
Re: Milling pockets in pistons	mopfried	02/27/18 01:05 AM
Re: Milling pockets in pistons	dizuster	02/27/18 10:08 PM
Re: Milling pockets in pistons	Von	02/27/18 11:47 PM
Re: Milling pockets in pistons	Stanton	02/28/18 12:19 AM
Re: Milling pockets in pistons	mopfried	02/28/18 01:02 AM
Re: Milling pockets in pistons	mopfried	02/28/18 04:09 AM
Re: Milling pockets in pistons	mopfried	02/28/18 03:44 PM
Re: Milling pockets in pistons	mopfried	03/01/18 01:48 AM
Re: Milling pockets in pistons	Sport440	03/01/18 03:32 AM
Re: Milling pockets in pistons	dizuster	03/01/18 04:05 AM
Re: Milling pockets in pistons	mopfried	03/01/18 06:39 AM
Re: Milling pockets in pistons	dizuster	03/01/18 06:37 PM
Re: Milling pockets in pistons	mopfried	03/01/18 07:13 PM
Re: Milling pockets in pistons	dizuster	03/01/18 10:44 PM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To