Quote:

Mancini Racing has pulley spacers if that is what you want. They sell a 0.375 thick spacer for the crank pulley to match the 0.375 thick motor plates.



I looked at that and I wish it was as simple. My previous plate was .250" thick and the crank pulley had a .850 spacer behind it. They were lined up perfect.
So, in effect, I need an additional .125 to equal the new .375" plate. 440 source has a .125 shim, but not sure I want to stack spacers and shims behind the pulley.

I'll get it figured out once I have the motor back in hand.