I had to remove the existing plastic fuel cell, and had an aluminum one fabbed to fit the same hole. Before I could have the flanges welded on, it all had to be test fitted to get it right. I had to remove the hold down for the factory jack, as well as the raised section for the gas neck filler tube, then, I determined the leafs were a little too close to leave it square on the bottom, and it had to be sectioned again...Then it was alll fitted up and I redid the entire trunck area.













'70 Cuda,...605 EFI Hemi Street Car (6.20 best pass, 1.33 60ft)
https://www.youtube.com/watch?v=WYw6RA-k5Bk (6.25 at 108.75mph from inside car)
https://www.youtube.com/watch?v=3zQEb9uxFng (6.25 at 108mph from outside car)
https://www.youtube.com/watch?v=JCvfzsC4NgM (9.9)

'66 Barracuda AWB Stretched nose Blown 440 Car in build stage

'71 Duster Drag Car 400 Low Deck 512 best 6.002 at 115.44mph
https://www.youtube.com/watch?v=Znuo3jMUXTk