Originally Posted By Bighead440
Any luck finding an unwanted drill fixture? I guess I can try to make one, but I know the placement is critical as far as having the bearing parting line and tangs precisely located..


Just put a bearing in a rod cap and drill the cap..
make sure the cap is seated... I bolted both halves
together first then unblolted it.. the bearing will
stay there.. get a set of bearings so you know the
hole size... and bolt each one together before drilling
and I'm talking both bearings before drilling the
one hole.. and make sure you have the right bearing
(if it has a taper for the crank side)
wave

Last edited by MR_P_BODY; 06/01/16 08:51 PM.