Originally Posted By 451Mopar
Originally Posted By Paul_Fancsali
Just one thing I ran into on a 2.5 take the cap and totor off and lift the plastic sensor plate and check to see if the plastic parts on main shaft of dist are still there and functioning I had to JB weld mine back together as mine was doing the very same thing { Timing was moving all over the place }


X2

The shutter wheel in the dist is a known for coming loose from the plastic base.



I have seen that also and I agree that of course that can make it run bad or not at all but he said it ran good at wide open throttle and seemed to run good cold. If this was the problem I would think it would effect it cold or hot or at WOT which is why I did not suspect that. And he did say it had set an 02 sensor code. But lets hope he has it fixed as it sounds like he does have it fixed now since he replaced some parts. Ron