I had a few PMs asking about the check valve shown in the picture. It is an Earls item, P/N 251008ERL, I got it either at Jegs or Summit. The pump is a Carter #P4070, I used it because it did not require an additional regulator - the pumps are rated 5-7 psi. I used #8 AN fittings (1/2") to reduce any potential plumbing resistance. I tried to make mine as simple as possible but still be neat. You can surely save some money by going with some generic fittings. I can't remember if these were Russell or Earls. If you go with the AN fittings just mock everything up loosely then you have to put a slight twist in the assembly to get it snug. I located the bracket in the axle tunnel using locations that were already there so no need to drill extra holes. One hose come up from the gas tank and the other hose connects to the fuel line on the frame. Everything fit just fine even with the Dana 60. Years ago on this forum I had supplied a full list by part # but can no longer find it...