Originally Posted By Sport440
Originally Posted By Cab_Burge
Originally Posted By gregsdart
Nice work on those screens up I need to go smaller mesh to stop needle bearings from getting down to the oil pump ,gear drive or oil pump gear. Anybody run anything with smaller mesh? I figured that it might work to put a finer mesh over the screen in the oil pan, but that might not protect the gear drive?

Putting mesh above the roller wheels won't stop the needles from falling out the bottom of the lifter bores, will it workI had two Mopar brand solid roller wheels break in half and get the cam, luckily I shut the motor off before sucking any of the needles bearing up into the oil pump shruggy




iagree Wont stop the needle bearings, but the screens are a good idea.


I've never broke a rocker that the needle bearings
came out(knock on wood) but have had lash caps and
broken PRs laying in the valley.. I dont want that
trash getting hung up on a cam or have it fall down
onto the crank/rods at 8000+ rpm.. that screen has
done its job for me a FEW times... the lifters are
below the screen so it might not help with them
but it does help for stuff up in the heads
wave