Originally Posted By BigAg
This is probally a dumb questions but is there anything special to screwing the fitting in? Any special mopar Gel or so to prevent it from leaking?


It's a pipe thread , it sort of is supposed to self seal , but you can put some type of pipe thread sealant /lube on it and screw it in , then clean off what is exposed before painting.

I bought a fitting that from a member in Maine a few years back that was made to fit the larger hole of the WP housing and go down to the smaller hose size.

I also made one , I found a HELP fitting that was the larger thread , and 5/8 hose but the internal hole was the size of a 1/2" barb,I chucked it in a lathe and turned it down to 1/2" barb size.

I still have it kicking around.


running up my post count some more .