Originally Posted By vette1986
I did some looking and I am really liking the Lunati roller cam kit: https://www.lunatipower.com/Product.aspx?id=4642&gid=365

Has anyone had any experience with this or another roller cam kit? I think this one looks good from my combo as I want some major torque down low but also a little top end until those stock manifolds cut me off around 5500. is it a pretty straight forward conversion? Will I need new pushrods(have crane ones in there now), a new dist drive? Just wondered what I will all be looking at and if it is worth it to do the roller or just do the Mr Six pack cam?

INPUT PLEASE!! up



The Lunati cam you have picked would make you very very happy. I have used the small block counterpart of that cam in a 360 and it has tons of vacuum, almost stock idle and pulls everywhere up until about 5800 rpm. If you are leaning towards a roller then go this way. If not, there are plenty of hydraulic flat tappets that can do what you are asking as well. J.Rob

2009 PHR\EMC Competitor
2010 PHR\EMC Competitor
2011 PHR\EMC Competitor
2012 PHR\EMC Competitor
2013 PHR\EMC Competitor
2014 HotRod/EMC Competitor
2015 HotRod/EMC NoShow
2016 HotRod/EMC 3rd place SPEC Bigblock
2018 HotRod/EMC 7th place G3