Originally Posted By Pynzo
This tool / screw kit works fine for the rear carb screws. You have to figure out exactly the route through the choke linkage, fuel line, vacuum lines, it fits and works both sides. Read thoroughly the instructions on the eBay page.
No need to get a ProMax setup. And you can use the stock screws for the front carb-

Edit- I'll be installing the tool before starting the engine. You can feel the ball end of the tool clip into the socket head idle screws.


Looks like I was wrong. That is the kit I got and looking at it (no flex in the tool) I figured "No Way" is that going to access the rear carb with straight screws, so I bought a Promax rear plate which is still a tight angle to get at and I'm using the stock screws in the Promax plate. From the your pictures it looks like I wasted my money on the Promax rear plate.


70 Roadrunner convt. street car 440+6, NOS, 4-spd, SS springs '96 Mustang GT convt. street car '04 4.6 SOHC, NOS, auto, lowered "Officer, that button is for short on-ramps"