Quote:

Quote:

Its 8mm.. I want to test it when I get home to see
if I need to grind the probe housing.. but at 8mm
I dont think I will




I purchased mine w/ a 6mm diameter flat-face probe and was the smallest they offered. I contacted the vendor about buying a second at the same time, because I suspected I was going to have to hand-fit one of them to read the curved surface of a cylinder bore properly... and I was right.

I spent some time w/ 600-grit wet-or-dry profiling the face of the probe to have a concave surface that appeared to seat properly against the inside of my 4.375" tapered ring compressor.




I was gonna spin up a 4" ID tube as a test piece
and contour to it.. I'll make it fit a 3.9" that
would be the smallest ID I'd measure..it should be
fine on OD