Quote:

---

Quote:

---

Unless you have all the tooling, are very good with dial indicators and have a bunch of experience, I would send them to Rocker Arm Specialties in California.

If you have the tooling and feel comforatable making fixtures and things, go for it.

---

Last I heard, RAS was no longer in existence. I hope I heard incorrectly.

---

You did, I had Gary bush, change ratio to 1.6 and blueprint 7 BB Mopar ductile iron rockers that I had here. I had them do a bunch of different brand, Mopar, Isky, Crane, Sig Erson and some cheaper no names, ductile iron rockers back in the early 1990s the same way as these are being done I've used them all up except the last nine I had so it is time to use them on my latest street pump gas stroker motor (512 C.I. 440 block) I'm making now with stock type heads. I sent them to him several weeks back, he quoted 2 to 3 weeks to finish them and he said Fridy he will ship them to me tomorrow, 2/16/20015. I'll post when they arrive and any appropriate comments