Quote:

---

Quote:

---

Quote:

---

Well, if you're really set on solid mounts and ambitious, you can always swap out the spool k-member for and sandwich type and use Moroso mounts! But that's more work than fabricating & welding the end caps on the spool mounts. One last option would be a motor plate. But that leaves a long, unsupported area between the water pump & trans mount. (Not good if the trans blows.)

Poly can't be that bad. It's debatable, but I've always liked the idea of a torque strap as well so the actual block isn't stressed, even with solid mounts.

---

Thought about the K-member swap too. I don't want to do that because it's still a fairly clean, stock #'s matching car (for the most part)...so I'm hesitant to do that. Guess I could keep the original...but I'd have to store it. That sucks.

I guess it's not just the poly I don't care for. I don't really like this style mount. Looks to me the only advantage is assembly at the factory. Otherwise...I can see no reason why the spool is better than the old system.

---

What, you think the motor only goes in at the factory??? A lot easier with the spool mounts, especially if you are leaving the trans in place. Don't really understand what your problem is?? - but - as said, weld plates on the ends of the spool mounts and you are there. No K member hassles.

---