Quote:

---

If your using green bearings you don't need the axle seals.They have o-rings and sealed bearings.Just apply a coating of RTV silicone in the housing bearing bores and install the axles.Trying to use axle seals will drive you crazy unless your using stock axles and housings,the aftermarket axles vary in diameter from different MFGs.Also tube diameters can vary as well as aftermarket housing ends.Some have no register for seals.

---

Precisely why I recommended Doctordiff as there's virtually no combination he hasn't seen. I have replaced dozens of radial ball bearings because the hot gear oil washed the thick grease from the bearing. BTW I use a stock housing with the tubes cut shorter and pressed back into the center section.I used stock seals and Moser axles and they seal just fine.
Gus