Quote:

Quote:

Quote:

You can get under the dash with a die grinder and cut the bolts and clips. Then put in new clips and run the bolts from the bottom up.






Good Luck with that.....kinda half A$$ if you ask me...




I never said I would do it that way but if you dont want to pull the glass, buy a new gasket and pay to have it re-installed what choice do you have.

I bet most people would never even notice the bolts upside down




Actually, that doesnt sound half bad. As mentioned, I'd hate to have to pay to have the windshield R & R'd just to put the dash frame in, but depends on the cost. Plus Id have to pay to have the windshield people come out twice; once to pull it, then again to install it once the new dash frame was in place.

I'll wait to see if anyone else chimes in with some ideas, but right now, that one is winning.

thanks for all the input so far


GY3 71 Demon 340